| Greddy 3 Row FMIC Install |
| Overall installing the Greddy FMIC on my Supra was not too complicated, but I would suggest setting aside a full day for this as it can be time consuming your first time installing one. Here is my install guide, I have made it to touch up on some things that I feel were not covered so well in the instructions. If you have any questions please feel free to email me at mark@jscspeed.com |
|
|
1.) Remove headlights by unbolting the 3 10mm bolts located in the highlighted areas. Unplug the 3 connecters in the back of headlight and remove headlight from car. |
|
|
2.) Unbolt 10mm bolts for splash gaurds and under panels and remove from car. Be sure to keep track of the bolts as these can get lost easily. |
|
|
3.) Remove factory intercooler piping by unbolting all 10mm bolts and clamps. |
|
|
4.) Next step is to remove the factory intercooler, it is bolted in with 2 12mm bolts and 1 12mm nut. Once these are removed lower intercooler out of car. |
|
|
5.) Unplug 4 wire connecters (2 on each side of the bumper) for turn signals and side markers. |
|
|
6.) Pull up on rubber seal and remove from car and unscrew all plastic screws and remove upper retainer. |
|
|
7.) Pull down on plastic clips to remove lower retainer. |
|
|
9.) Unbolt 2 bolts on either side of the bumper and remove bumper. |
|
|
10.) Remove coolant reservoir by unbolting 2 10mm bolts and 1 10mm nut. |
|
|
11.) Unbolt 4 bolts on each hood latch (Do not remove latches) |
|
|
12.) Remove plastic duct cover by unscrewing all plastic screws and unplug ambient air temp. sensor. Pop hood latch cable box from cover and then remove hood latches.(passenger latch has sensor plugged into it) |
|
|
13.) Unbolt plastic panels from both sides by removing 3 10mm bolts and 2 plastic stay screws. Trim bracket from chassis flat so that intercooler piping will fit through. |
|
|
14.) Drain power steering reservoir by unclamping this hose. |
|
|
15.) Remove power steering cooler by unbolting all 10mm bolts from brackets and relocate to driver side vent using supplied cooler and bracket. |
|
|
16.) Remove OEM AC bracket and relocate AC line using supplied bracket. |
|
|
17.) Reattach hood latches and bolt down. Install intercooler core using supplied hardware and tighten down. |
|
|
18.) Install all intercooler piping and check clearances. |
|
|
19.) Reinstall front bumper, splash guards, headlights, and turn signal plugs. |
| |
 |